SAE AIR1388 Service Damage Limits for Aircraft Hydraulic Tubing
时间:2024-05-20 00:33:37 来源: 标准资料网 作者：标准资料网 阅读：8738
Product Code:SAE AIR1388
Title:Service Damage Limits for Aircraft Hydraulic Tubing
Issuing Committee:G-3, Aerospace Couplings, Fittings, Hose, Tubing Assemblies
Scope: This SAE Aerospace Information Report (AIR) is intended to assist in evaluating the serviceability of damaged hydraulic tubing lines. The performance requirements are outlined to which the defect sample were tested. Test methods and data are described and summarized. Permissible defect limits are listed for 6061-T6 aluminum return lines, 3000 psi hydraulic tubing of 21Cr-6Ni-9Mn SS, 304 1/8 hard, corrosion resistant steel (CRES), as well as 3Al-2.5V CWRS and 3Al-2.5V annealed, seamless titanium tubing. All dimensions are in inches unless otherwise noted.
Product Code:SAE ARP584
Title:Coiled Tubing, Corrosion Resistant Steel, Hydraulic Applications, Aerospace
Issuing Committee:A-6c4 Tubing Committee
Scope: This SAE Aerospace Recommended Practice (ARP) encompasses design, analysis, fabrication, and installation of pressurized metal tubing used in fluid power systems to provide relative motion. Specific data given are for MIL-T_6845 tubing ranging from 1/4 to 1 in. (6.3 to 25 mm) to diameter used in 3000 psi (20.7 MPa) hydraulic or pneumatic system, Military Type I, II, III, or IV hydraulic systems applied to any type of vehicle. For information on design of coiled tube assemblies using Ti-3Al-2.5CWSR tubing, see ARP4146. The flexible configurations of tubing are intended for application to actuators that oscillate about a pivot, to areas of large structural deflection such as reservoirs installation, and to areas of extrement environment where flexible hose could not survive.
Rationale: This SAE Aerospace Recommended Practice (ARP) encompasses design, analysis, fabrication, and installation of pressurized metal tubing used in fluid power systems to provide relative motion. Specific data given are for MIL-T_6845 tubing ranging from 1/4 to 1 in. (6.3 to 25 mm) to diameter used in 3000 psi (20.7 MPa) hydraulic or pneumatic system, Military Type I, II, III, or IV hydraulic systems applied to any type of vehicle. For information on design of coiled tube assemblies using Ti-3Al-2.5CWSR tubing, see ARP4146. The flexible configurations of tubing are intended for application to actuators that oscillate about a pivot, to areas of large structural deflection such as reservoirs installation, and to areas of extrement environment where flexible hose could not survive.【英文标准名称】:Industrial-processcontrolvalves-Specificationformarking
【原文标准名称】:工业过程控制阀.第5部分:标记规范
【标准号】:BS5793Pt.5-1984
【标准状态】:作废
【国别】:
【发布日期】:
【实施或试行日期】:
【发布单位】:英国标准学会(GB-BSI)
【起草单位】:
【标准类型】:()
【标准水平】:()
【中文主题词】:
【英文主题词】:
【摘要】:
【中国标准分类号】:
【国际标准分类号】:
【页数】:
【正文语种】: